實踐中，單片機端口在連接開關器件時都要考慮消抖的問題，或在硬件上增加延遲，或是增加軟件延遲查詢的功能模塊。這里，我們考慮這樣一個檢測電路：單片機連接一個開關和兩個LED。程序是這樣的，如果開關的消抖正確，就點亮LED1，否則就閃亮LED2。按下開關，點亮LED1，釋放開關，LED1即熄滅。我們加入20毫秒的消抖延遲時間。當檢測到開關為低電平時，單片機在延遲20毫秒后再次檢測開關的狀態。如果此時開關狀態為高，則LED2就閃亮，如為低則點亮LED1。源代碼：
本文引用地址：
http://yuyingmama.com.cn/article/201611/321250.htmled1bitP2.0
led2bitP2.1
switch1bitP1.0
ORG 0000h
setb switch1//initialize switch 1 as input
setb led1//Turn OFF LED1
setb led2//Turn OFF LED2
wait:
jb switch1,wait// Wait till switch1 has been pressed
call debounce_delay
jb switch1,c1_wait
//switch low even after debouncing period
//switch has been succesfully debounced
clr led1//Turn ON LED1
jnb switch1,$//wait till switch has been released
setb led1//Turn OFF LED1
ajmp wait
c1_wait:
//Switch PIN high after debounce period so error in debouncing
cpl led2
ajmp wait
debounce_delay://Subroutine for generating 20ms delay
mov r7,#245
l1_debounce_delay:
mov r6,#40
djnz r6,$
djnz r7,l1_debounce_delay
ret
END
加入技術交流群
評論