日本a√视频在线,久久青青亚洲国产,亚洲一区欧美二区,免费g片在线观看网站

        <style id="k3y6c"><u id="k3y6c"></u></style>
        <s id="k3y6c"></s>
        <mark id="k3y6c"></mark>
          
          

          <mark id="k3y6c"></mark>

          新聞中心

          EEPW首頁 > 模擬技術 > 設計應用 > 隔離式電源電信應用-Isolated Power Suppl

          隔離式電源電信應用-Isolated Power Suppl

          作者: 時間:2011-04-13 來源:網絡 收藏
          bove its corner frequency and a phase shift of 180°.

          隔離式電源電信應用-Isolated Power Suppl
          Figure 11. These Bode plots depict a single-pole RC network and a double-pole LC network.

          As an example, consider the compensation of a power supply operating at 70kHz with a duty cycle of 50%, described by the power-supply characteristic of Figure 12. The maximum corner frequency is fSWITCHING/(2x3.14xD) = 22kHz. Beyond this corner frequency, the output capacitor, the inductor, and the load resistor produce a -40dB/decade attenuation and a 180° phase shift. The op amp's bandwidth is more than 10MHz, but its associated RC components introduce a pole and zero, to compensate phase lag introduced by the LC pole and to provide at least 45° of phase margin at fC.

          隔離式電源電信應用-Isolated Power Suppl
          Figure 12. Simplified Bode plots depict a power-supply output and its compensation network.

          To ensure good output-voltage regulation at DC, a pole in the error amplifier reduces the gain by -20dB/decade. A zero caused by R2-C2 modifies the gain slope to 0dB/decade, and R2-C1 causes a gain increase to +20dB/decade. As a result, phase introduced by the compensated op amp starts at -90° (due to the first pole), goes to 0° (due to R2-C2), and rises to +90° (due to R2-C1). Summing the output-LC and compensated-op-amp characteristics gives the overall result (dotted line), which indicates a power supply compensated with fC = 22kHz and a phase margin of 90°.

          ________________________

          1Per the American UL Standard (also adopted by the European EN60950 Standard), clearance is the minimum-allowed distance specified for separation of uninsulated conductive surfaces of opposite polarity. Creepage is a corresponding distance between two such surfaces, measured along any connecting surfaces (rather than the line-of-sight through-air distance specified for clearance).
          2Per the American UL Standard (also adopted by the European EN60950 Standard), pollution degree 2 environments can have nonconductive contaminants or temporary conductivity caused by condensation. Pollution degree 3 environments can have conductive contaminants.

          上一頁 1 2 3 4 下一頁

          評論


          相關推薦

          技術專區

          關閉